Thread Inspectors - Casing


Job Title: Thread Inspector                                                                                      Date: ____________


Department: End Finish                     


Supervisor’s Title: End Finish Lead Person


Training Requirements:

1.       TTP Orientation.

2.       Company Basic practices; Safety, QA & HR Policy.

3.       Relevant Standard Operating Procedures.

4.       Identification and traceability, Product marking and Test Status activities.

5.       Control of Non-conformances.


Education Requirements:

Minimum of High School diploma or GED.


Experience Requirements:

1.       Minimum 3 months of thread inspection experience.

2.       Through knowledge of handling gages.

3.       Ability to read and understand Work Order Instructions and acceptance criteria of the product.



1.       Verify product identification of material to be inspected.

2.       Set-up gages and gage the parts as per the requirements.

3.       Interpret and understand drawings and work order requirements.

4.       Check material against work order instruction sheet.

5.       Check and verify calibration on the equipment.

6.       Check product for lead, taper, thread height and standoff, etc. as per work order instruction or standard operation procedure.

7.       Report and document inspection findings.

8.       Immediately communicate any out of tolerance issues to the CNC operator. While performing the duties of this job, the employee is regularly required to stand; walk; use hands to finger, handle, or feel; reach with hands and arms; and talk or hear. The employee frequently is required to stoop, kneel, crouch, or crawl. The employee is occasionally required to sit. The employee must be able to lift and/or move up to 50 pounds. Specific vision abilities required by this job include close vision, color vision, peripheral vision, depth perception, and ability to adjust focus.

9.       Position requires to be exposed to High temperatures depending on the season. The position also requires to be exposed to noise levels ranging from moderate to high.

10.   NOTE: This job description is not intended to be all-inclusive. Employee may perform additional related duties, as per management, to meet the ongoing needs of the organization.


Tools and Equipment:

Lead gauge, Taper gauge, Thread height gauge, Standoff gauge, Pitch diameter gauge, Profile gauge, etc.

TEJAS TUBULAR PRODUCTS INC is an EEO employer - M/F/Vets/Disabled
By clicking the button, I agree to the GetHired Terms of Service member? Login to Apply